User`s manual

P-660 Series Support Notes
179
All contents copyright © 2005 ZyXEL Communications Corporation.
is?imeinterval?before starting
again. The time-based default
is 2 hrs
defectcheck [on|off] Turn on/off detect table
checking, default is on
txgain [value] Set the CTRLE register
(0xc3), the value is from 0xfa
to 0x06
targetnoise [value] Set the CTRLE register
(0xc4), the value is from 0xfa
to 0x06
maxtonelimit [value] Set the CTRLE register
(0xc5), the value is from 0xfa
to 0x06
rxgain [value] Set the CTRLE register
(0xc6), the value is from 0xfa
to 0x06
txoutputpwr [value] Set the CTRLE register
(0xc7), the value is from 0xfa
to 0x06
rxoutputpwr [value] Set the CTRLE register
(0xc8), the value is from 0xfa
to 0x06
maxoutputpwr [value] Set the CTRLE register
(0xc9), the value is from 0xfa
to 0x06
errorsecond
sendes Send current error second
information immediately
dygasprecover
dygasprecover level [value] By default is 100, after
receiving 100 dying gasp
system will reboot
dygasprecover active [on|off| Turn on/off this mechanism
rsploss [1|0] Turn on means to response
signal loss of CTRLE
immediately, default is off
atm test [fix|rand|period|oam|loopback] Generate ATM traffic
hwsar disp Display hwsar packets
incoming/outgoing
information
clear Clear hwsar packets
information
6. PPP Related Command
Command Description
ppp
bod
remote <iface> show remote bod
information
reset reset bod
setremote <iface> set remote bod
status <wan_iface> show wan port bod
status
clear <wan_iface> clear wan port bod data