User`s manual

P-660 Series Support Notes

162

configurations

[cppwu@faelinux cppwu]$ tftp -I 192.168.1.1 put [local-rom] rom-0 <- upload configurations

[cppwu@faelinux cppwu]$ tftp -I 192.168.1.1 get ras [local-ras ] <- download firmware

[cppwu@faelinux cppwu]$ tftp -I 192.168.1.1 put [local-ras] ras <- upload firmware

3. Using FTP to Upload the Firmware and Configuration Files

In addition to upload the firmware and configuration file via the console port and

TFTP client, you can also upload the firmware and configuration files to the Prestige

using FTP.

To use this feature, your workstation must have a FTP client software. There are two

examples as shown below.

• Using FTP command in terminal

• Using FTP client software

Using FTP command in terminal

Step 1

Use FTP client from your workstation to connect to the Prestige by entering

the IP address of the Prestige.

Step2

Press 'Enter' key to ignore the username, because the Prestige does not check

the username.

Step 3

Enter the SMT password as the FTP login password, the default is '1234'.

Step 4

Enter command 'bin' to set the transfer type to binary.

Step 5

Use 'put' command to transfer the file to the Prestige.

Note: The remote file name for the firmware is 'ras' and for the configuration file is

'rom-0' (rom-zero, not capital o).

Example: