User`s manual

P-660 Series Support Notes

103

hunting

• Using Zero configuration.

1. After configure the auto-haunting preconfigured table. You just need a PC

connected to the device LAN Ethernet port with the DSL sync up.

2. Open your web browser to access a Web site. It should prompt and request

for your username password of your ISP account, if your ISP provide PPPoE

or PPPoA service.

3. After key-in the correct info, it will than test the connection. If it is

successful it will than close the browser and you can open a new browser to

surf the Internet. If the connection test fail, it will go back to the page ask for

user name and password.

The user name or password are incorrect. You need to keyin again to retry.

Basically the zero configuration only work on the VC that was preconigured in

the auto-haunting preconfigured table.