User`s manual

P-660 Series Support Notes
102
All contents copyright © 2005 ZyXEL Communications Corporation.
wan atm vchunt remove <remote node> <vpi> <vci>
5. The usage command argument is listed below suggest to use 3f which include
all PPP possiblities.
Command Description
wan atm vchunt
Add <remoteNodeIndex>
<vpi> <vci> <service
bit(hex)>
Add a entry to hunting pool
<remote node> : input the
remote node index 1-8
<vpi> : vpi value
<vci> : vci value
<service>: it’s a hex value,
bit0:PPPoE/VC (1),
bit1:PPPoE/LLC (2) ,
bit2:PPPoA/VC (4),
bit3:PPPoA/LLC (8),
bit4:Enet/VC (16),
bit5 :Enet/LLC (32)
For examples:
If you need service PPPoE/LLC
and Enet/LLC then the service
bits will be 2+32 = 34 (decimal)
= 22 (hex), you must input 22
Need to perform save after this
command
Remove <removeNodeId>
<vpi> <vci>
Input remote node ID and vpi,
vci value to remove the specific
entry. System will save
automatically.
Active <yes|no> Enable VC auto hunting featurer
display Display the hunt pool
Clear Clear the configure buffer
Save Save current setting into ROM
file
timer The waiting time before
checking the hunting table result
Send Send VC hunt pattern again
result Check the result of VC auto