User`s manual

P-660 Series Support Notes

100

Protocol ID

Enter the protocol number for the traffic. 1 for ICMP, 6 for TCP or 17 for UDP

After configuration BWM, you can check current bandwidth of the configured traffic

in ADVANCED->BWM MGMT->Monitor. The values in the column of Current

usage (kbps) would display the actually number.

15. Using Zero-Configuration

• Zero-Configuration and VC auto-hunting

Zero-Configure feature can help customer to reduce the burden of setting efforts.

Whenever system ADSL links up system will send out some probing patterns, system

will analyze the packets returned from ISP, and decide which services the ISP may

provide. Because ADSL is based on a ATM network, so system have to pre-

configured a VPI/VCI hunting pool before Auto-Configure function begins to work.

The Zero-Configuration feature can hunt the encapsulation and VPI/VCI value, and

system will automatically configure itself if the hunting result is successfully. This

feature has two constraints:

1. It supports the ISP provides one kind of service (PPPoE/PPPoA..etc.) only,

otherwise the hunting will get confusing and failed.

2. VC auto-hunting only supports dynamic WAN IP address. If the router is set a

static WAN IP address. VC auto-hunting function will be disabled.

The entry of hunting pool must also contain the VPI, VCI, and which kinds of hunting

patterns you wish to send. Whenever system send out all the probing patterns with

specific VPI/VCI, system will wait for 5~10 seconds and get the response from ISP,

the response patterns will decide which kinds of ADSL services of the line will be.

After that, system will save back the correct VPI, VCI and also services

(encapsulation) type into profile of WAN interface.

• Configure the VC auto-hunting preconfigured table.

1. Display auto-haunting preconfigured table by using CI command from menu 24.8:

wan atm vchunt disp