Wireless Firewall Router User's Guide

P-335 Series User’s Guide
167 Chapter 13 VPN Screens
Figure 85 Summary
The following table describes the labels in this screen.
Table 68 Summary
LABEL DESCRIPTION
# The VPN policy index number.
Active This field displays whether the VPN policy is active or not.
The icon is turned on when this VPN policy is active.
Click the edit icon under Modify and select the Active checkbox in the Rule
Setup screen to activate the VPN policy. Clear the checkbox to dieactivate this
VPN policy without having to delete the entry.
Local Addr. This is the IP address of the computer on your local network behind your Prestige.
Remote Addr. This is the IP address(es) of computer(s) on the remote network behind the
remote IPSec router.
A single (static) IP address is displayed when the Remote Address Start and
Remote Address End/Mask fields in the Rule Setup IKE (or Manual) screen are
both configured to the same IP address.
The beginning and ending (static) IP addresses, in a range of computers are
displayed when the Remote Address Start and Remote Address End/Mask
fields in the Rule Setup IKE (or Manual) screen are configured for a range of IP
addresses.
A (static) IP address and a subnet mask are displayed when the Remote Address
Start and Remote Address End/Mask fields in the Rule Setup IKE (or Manual)
screen are configured for a subnet.
This field displays 0.0.0.0 when the Secure Gateway Address field is set to
0.0.0.0. In this case only the remote IPSec router can initiate the VPN.
Encap. This field displays Tunnel or Transport mode (Tunnel is the default selection).
Algorithm This field displays the security protocols used for an SA.
Both AH and ESP increase Prestige processing requirements and
communications latency (delay).
Gateway This is the static WAN IP address or URL of the remote IPSec router. This field
displays 0.0.0.0 when you configure the Secure Gateway Addr field in the Rule
Setup IKE screen to 0.0.0.0.
Modify Click the Edit icon to open the rule setup screen. Modify a VPN policy or create a
new VPN policy in the Rule Setup screen.
Click the edit icon next to an empty VPN policy index number to add a new VPN
policy.
Click the Remove icon to delete a VPN policy. When a VPN policy is deleted,
subsequent policies do not move up in the list.