Wireless Firewall Router User's Guide

P-335 Series User’s Guide
Chapter 5 Wireless LAN (P-335WT) 102
Figure 51 Advanced
The following table describes the labels in this screen.
Table 39 Advanced
LABEL DESCRIPTION
Roaming Configuration
Enable
Roaming
Select the check box to enable roaming on the Prestige if you have two or more
Prestiges on the same subnet.
Note: All APs on the same subnet and the wireless stations must
have the same SSID to allow roaming.
Port Enter the port number to communicate roaming information between APs. The port
number must be the same on all APs. The default is 3517. Make sure this port is not
used by other services.
Wireless Advanced Setup
RTS/CTS
Threshold
Enter a value between 0 and 2432. If you select the G+ Enhanced checkbox a value
of 4096 is displayed.
Fragmentation
Threshold
It is the maximum data fragment size that can be sent. Enter a value between 256 and
2432. If you select the G+ Enhanced checkbox a value of 4096 is displayed.
Preamble Select a preamble type from the drop-down list menu. Choices are Long, Short or
Dynamic. The default setting is Long. See the section on preamble for more
information.
802.11 Mode Select 802.11b Only to allow only IEEE 802.11b compliant WLAN devices to
associate with the Prestige.
Select 802.11g Only to allow only IEEE 802.11g compliant WLAN devices to
associate with the Prestige.
Select Mixed to allow either IEEE802.11b or IEEE802.11g compliant WLAN devices
to associate with the Prestige. The transmission rate of your Prestige might be
reduced.
G+ Enhanced Select G+ Enhanced checkbox to allow any ZyXEL WLAN devices that support this
feature to associate with the Prestige at higher transmission speeds. This permits the
Prestige to transmit at a higher speed than the 802.11g Only mode.
Apply Click Apply to save your changes back to the Prestige.
Reset Click Reset to reload the previous configuration for this screen.