User`s guide

Chapter 8 Basic Setting
XS1920 Series User’s Guide
69
8.7 Port Setup
Use this screen to configure Switch port settings. Click Basic Setting > Port Setup in the
navigation panel to display the configuration screen.
Figure 46 Basic Setting > Port Setup
Add Click Add to insert the entry to the summary table below and save your changes to the
Switch’s run-time memory. The Switch loses these changes if it is turned off or loses
power, so use the Save link on the top navigation panel to save your changes to the
non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Summary Table
Index This field displays the index number of the rule. Click an index number to edit the rule.
IP Address This field displays the IP address.
IP Subnet Mask This field displays the subnet mask.
VID This field displays the ID number of the VLAN group.
Type This field displays whether this IP interface has a static or DHCP-assigned IP address.
Delete Select the entries you want to remove.
Delete Click Delete to remove the selected entry from the summary table.
Note: Deleting all IP subnets locks you out of the Switch.
Cancel Click Cancel to clear the selected check boxes in the Delete column.
Table 16 Basic Setting > IP Configuration (continued)
LABEL DESCRIPTION