User`s guide

Chapter 5 Initial Setup Example
XS1920 Series User’s Guide
41
Figure 19 Initial Setup Network Example: Port VID
1 Click Advanced Applications > VLAN > VLAN
Configuration in the navigation panel. Then
click the VLAN Port Setup link.
2 Enter 2 in the PVID field for port 2 and click
Apply to save your changes back to the run-time
memory. Settings in the run-time memory are
lost when the Switch’s power is turned off.
5.2 Configuring Switch
Management IP Address
The default management IP address of the Switch is 192.168.1.1. You can configure another IP
address in a different subnet for management purposes. The following figure shows an example.
Figure 20 Initial Setup Example: Management IP Address
1 Connect your computer to any Ethernet port on the Switch. Make sure your computer is in the same
subnet as the Switch.
2 Open your web browser and enter 192.168.1.1 (the default IP address) in the address bar to access
the web configurator. See Section 4.2 on page 32 for more information.