User`s guide

Chapter 40 Access Control
XS1920 Series User’s Guide
334
40.5 Service Port Access Control
Service Access Control allows you to decide what services you may use to access the Switch. You
may also change the default service port and configure “trusted computer(s)” for each service in
the Remote Management screen (discussed later). Click Access Control to go back to the main
Access Control screen.
Figure 239 Management > Access Control > Service Access Control
The following table describes the fields in this screen.
Privilege Type the privilege level for this user. At the time of writing, users may have a privilege
level of 0, 3, 13, or 14 representing different configuration rights as shown next.
• 0 - Display basic system information.
• 3 - Display configuration or status.
• 13 - Configure features except for login accounts, SNMP user accounts, the
authentication method sequence and authorization settings, multiple logins,
administrator and enable passwords, and configuration information display.
• 14 - Configure login accounts, SNMP user accounts, the authentication method
sequence and authorization settings, multiple logins, and administrator and enable
passwords, and display configuration information.
Users can run command lines if the session’s privilege level is greater than or equal to the
command’s privilege level. The session privilege initially comes from the privilege of the
login account. For example, if the user has a privilege of 5, he/she can run commands
that requires privilege level of 5 or less but not more.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 172 Management > Access Control > Logins (continued)
LABEL DESCRIPTION
Table 173 Management > Access Control > Service Access Control
LABEL DESCRIPTION
Services Services you may use to access the Switch are listed here.
Active Select this option for the corresponding services that you want to allow to access the
Switch.
Service Port For FTP, HTTP or HTTPS services, you may change the default service port by typing the
new port number in the Service Port field. If you change the default port number then
you will have to let people (who wish to use the service) know the new port number for
that service.