User`s guide

Chapter 34 Link Layer Discovery Protocol (LLDP)
XS1920 Series User’s Guide
286
34.8 LLDP-MED Network Policy
Click Advanced Application > LLDP > LLDP-MED Network Policy (Click Here) to display the
screen as shown next.
Figure 201 Advanced Application > LLDP > LLDP-MED Network Policy
The following table describes the labels in this screen.
Table 142 Advanced Application > LLDP > LLDP-MED Network Policy
LABEL DESCRIPTION
Port Enter the port number to set up the LLDP-MED network policy.
Application Type Select the type of application used in the network policy.
•voice
• voice-signaling
• guest-voice
• guest-voice-signaling
• softphone-voice
• video-conferencing
•streaming-video
• video-signaling
Tag Select to tag or untag in the network policy.
• tagged
• untagged
VLAN Enter the VLAN ID number. It should be from 1 to 4094. For priority tagged frames,
enter “0”.
DSCP Enter the DSCP value of the network policy. The value is defined from 0 through 63 with
the 0 representing use of the default DSCP value.
Priority Enter the priority value for the network policy.
Add Click Add after finish entering the network policy information. A summary table will list
all the Switch you’ve added.
Cancel Click Cancel to begin entering the information afresh.