User`s guide

Chapter 21 Classifier
XS1920 Series User’s Guide
169
21.4 Classifier Example
The following screen shows an example where you configure a classifier that identifies all traffic
from MAC address 00:50:ba:ad:4f:81 on port 2.
After you have configured a classifier, you can configure a policy (in the Policy screen) to define
action(s) on the classified traffic flow.
Interval Select the length of the time period (in seconds) to count matched packets for a classifier rule.
Enter an integer from 0-65535. 0 means that no logging is done.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 76 Advanced Application > Classifier Configuration > Classifier Global Setting
LABEL DESCRIPTION