Product manual

- 8 -
004CC1
1- Introduction and safety
Available versions
The CDD described in this manual is available in a single version suitable for all countries of installation. It is
required that the CDD be installed with any MICRO inverter in compliance with UL1741, for the purpose of
indication and resetting of ground faults.
The device can be associated with the following MICRO inverter equipment from ABB:
0.25 kW models MICRO-0.25-I-OUTD-US-208/240
0.3 kW models
MICRO-0.3-I-OUTD-US-208/240
MICRO-0.3HV-I-OUTD-US-208/240
Product label
The sample product label is afxed to the inverter and provides the following information:
CDD Part Number
CDD Serial Number
WIFI communication MAC address
Radio frequency communication MAC address
Ethernet MAC address
When registering the CDD on the Easy View portal, the MAC RF (radio frequency)
address is used as the product identication code (see System monitoring, Part 6).
Regulatory nameplate
The nameplate shown is afxed to the inverter and provides the following information:
Technical data reported in this manual does not replace the data on the labels afxed
to the equipment.
P/N: PPPPPPPPPPP
S/N: YYWWSSSSSS
MAC WIFI:
MAC RF:
MAC ETH:
A1:B1:C1:D1:E1:F1
A2:B2:C2:D2:E2:F2:G2:H2
A3:B3:C3:D3:E3:F3
CONCENTRATOR DATA DEVICE MODEL: CDD
®
Contains FCC ID: X6W-EMBZ
INPUT DC : 5V , 0.5 A
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:(i.) this device may not cause harmful interference and
(ii.) this device must accept any interference received, including interference
that may cause undesired operation.
Contains FCC ID: W70ZG2100-ZG2101
www.abb.com/solar
Made in Italy