User`s guide

Chapter 1 Introducing the ZyXEL Device
P-2602HWUDL-D User’s Guide
50
2 To set the device back to the factory default settings, press the RESET button for ten
seconds or until the POWER LED begins to blink and then release it. When the
POWER LED begins to blink, the defaults have been restored and the device restarts.
1.7 The WLAN Button
You can use the ON/OFF WLAN button ( ) on the top of the device to turn the wireless
LAN off or on. You can also use it to activate OTIST in order to assign your ZyXEL Device’s
wireless security settings to wireless clients.
1.7.1 Turn the Wireless LAN Off or On
1 Make sure the POWER LED is on (not blinking).
2 Press the WLAN button for one second and release it. The WLAN LED should change
from on to off or vice versa.
1.7.2 Activate OTIST
1 Make sure the POWER LED is on (not blinking).
2 Press the WLAN button for five seconds and release it. The WLAN LED should flash
while the device uses OTIST to send wireless settings to OTIST clients.
" You must activate OTIST in the ZyXEL Device and in the wireless device(s)
within three minutes of each other. See Section 10.6 on page 165 for more
information.