User`s guide

Chapter 29 Tools
P-2602HWUDL-D User’s Guide
418
Refer to Section 29.3 on page 410 to read about configurations that disallow TFTP and FTP
over WAN.
29.8 Using FTP or TFTP to Restore Configuration
This section shows you how to restore a previously saved configuration. Note that this
function erases the current configuration before restoring a previous back up configuration;
please do not attempt to restore unless you have a backup configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to your device
since FTP is faster. Please note that you must wait for the system to automatically restart after
the file transfer is complete.
1 Do not interrupt the file transfer process as this may PERMANENTLY
DAMAGE your device. When the Restore Configuration process is complete,
the device automatically restarts.
29.8.1 Restore Using FTP Session Example
Figure 315 Restore Using FTP Session Example
Refer to Section 29.3 on page 410 to read about configurations that disallow TFTP and FTP
over WAN.
29.9 FTP and TFTP Firmware and Configuration File Uploads
This section shows you how to upload firmware and configuration files.
Binary Transfer the file in binary mode.
Abort Stop transfer of the file.
Table 172 General Commands for GUI-based TFTP Clients (continued)
COMMAND DESCRIPTION
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit