User`s guide

Chapter 23 Remote Management Configuration
P-2602HWUDL-D User’s Guide
339
Figure 231 Remote Management: WWW
The following table describes the labels in this screen.
23.3 Telnet
You can use Telnet to access the ZyXEL Device’s command line interface. Specify which
interfaces allow Telnet access and from which IP address the access can come.
23.4 Configuring Telnet
Click Advanced > Remote MGMT > Te l n e t tab to display the screen as shown.
Table 125 Remote Management: WWW
LABEL DESCRIPTION
Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Access Status Select the interface(s) through which a computer may access the ZyXEL Device
using this service.
Secured Client IP A secured client is a “trusted” computer that is allowed to communicate with the
ZyXEL Device using this service.
Select All to allow any computer to access the ZyXEL Device using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyXEL Device using this service.
Apply Click Apply to save your settings back to the ZyXEL Device.
Cancel Click Cancel to begin configuring this screen afresh.