User`s guide

Chapter 13 VoIP Trunking
P-2602HWUDL-D User’s Guide
225
Figure 160 VoIP > Trunking > General
Each field is described in the following table.
13.6 Trunking Peer Call Screen
Use this screen to set up outgoing authentication accounts for forwarding calls through peer
devices (without proxy) and incoming authentication accounts for forwarding calls from peer
devices. To access this screen, click VoIP > Trunking > Peer Call.
Table 73 VoIP > Trunking > General
LABEL DESCRIPTION
Enable Trunking
Select this to turn on VoIP trunking on your ZyXEL Device.
Auto Attendant
Timeout
This setting determines how long the ZyXEL Device waits for a caller to enter a
phone number (to which the ZyXEL Device forwards the call) when it receives the
call. Enter a value from 1 to 255 seconds.
If you do not dial any number(s) before the auto attendant times out, the phone
directly connected to the ZyXEL Device rings.
If you enable Auto Attendant Authentication, after you dial a phone number, the
ZyXEL Device prompts you to enter the password.
Dialing
Interval(sec)
Enter the number of seconds the ZyXEL Device should wait after you stop dialing
numbers before it makes the phone call. The value depends on how quickly you
dial phone numbers. The default value is 3 seconds and entering 0 does not
change the default. Enter a value from 1 to 255 seconds.
Enable Auto
Attendant
Authentication
Select this to enable authentication for calls coming into your ZyXEL Device. This
is similar to enabling a PIN (Personal Identification Number) that callers must
enter to forward calls via your ZyXEL Device.
Password
This is the PIN callers have to enter via their phone pad when dialing into your
ZyXEL Device to forward calls through it. Enter a number between 1 and 32 digits
long.
Apply
Click this to save your changes and to apply them to the ZyXEL Device.
Cancel
Click this to reset the fields.