User`s guide

Chapter 10 Wireless LAN
P-2602HWUDL-D User’s Guide
166
Figure 117 Network > Wireless LAN > OTIST
The following table describes the labels in this screen.
Before you click Start, you should enable OTIST on all the OTIST-enabled devices in the
wireless network. For most devices, follow these steps.
1 Start the ZyXEL utility
2 Click the Adapter tab.
3 Select the OTIST check box, and enter the same Setup Key as the ZyXEL Device.
4 Click Save.
Table 41 Network > Wireless LAN > OTIST
LABEL DESCRIPTION
Setup Key Type a key (password) 8 ASCII characters long.
Note: If you change the OTIST setup key in the ZyXEL Device, you
must change it on the wireless devices too.
Yes! Select this if you want the ZyXEL Device to automatically generate a pre-shared key for
the wireless network. Before you do this, click Network > Wireless LAN > General
and set the Security Mode to No Security.
Clear this if you want the ZyXEL Device to use a pre-shared key that you enter. Before
you do this, click Network > Wireless LAN > General, set the Security Mode to WPA-
PSK, and enter the Pre-Shared Key.
Start Click Start to activate OTIST and transfer settings. The process takes three minutes to
complete.
Note: You must click Start in the ZyXEL Device and in the wireless
device(s) within three minutes of each other. You can start
OTIST in the wireless devices and the ZyXEL Device in any
order.