User`s guide

Prestige 128+ ISDN Router
2-4 Hardware Installation and Setup
Step 1. Connecting the ISDN Line
Connect the Prestige to the ISDN network using the included ISDN (black) cable.
Plug one end of the cable into the port labeled ISDN BRI and the other to the
ISDN wall jack.
Step 2. Connecting Ethernet to your Prestige
The Prestige supports two types of Ethernet connections. The connection
procedure differs for each one; follow the one that is appropriate for your
installation.
♦ UTP
The UTP port is used to connect to a 10Base-T network. 10Base-T networks use
Unshielded Twisted Pair (UTP) cable and RJ-45 connectors that look like a
bigger telephone plug with eight pins.
♦ AUI
The AUI port (the connector with 15 pins) is used to connect the Prestige to a
10Base5 (thicknet) network. If you have a 10Base2 network using BNC
connectors and thin coaxial cables, you will need a transceiver between the AUI
port and the 10Base2 cabling.
Warning If one of these cables is accidentally used to connect your
Prestige to the ISDN line, it may damage your Prestige. Please verify the
correct cable before connecting.
Step 2. Connecting a Telephone/Fax to the Prestige
If you wish, you can connect regular telephones, fax machines or other analog
devices to the Prestige. To connect an analog device, plug the end of the
telephone cord from the device in either port PHONE1 or PHONE2 on the rear
panel of the Prestige.