User`s guide

Prestige 128+ ISDN Router
15-14 System Maintenance
RAS and ISDN code update - Type ‘atur’ and wait until the Prestige responds
with an OK to begin uploading the new software (upload procedure varies
depending on the type of software used to access the Prestige). You must use the
XMODEM protocol to perform the upload. After uploading is successful, type
‘atgo’ to start your Prestige.
Figure 15-11 Menu 24.7 - System Maintenance - Upload Firmware
15.6.1 Boot module commands
Prestige boot module commands are shown below. For ATBAx, x denotes the
number preceding the colon to give the baud rate following the colon in the list of
numbers that follows; e.g. ATBA3 will give a baud of 9.6 kbps. ATSE displays
the seed that is used to generate a
password to turn on the debug flag in the firmware. The ATSH command shows
product related information such as boot module version, vendor name, product
model, RAS code revision, ISDN code revision, etc.
======= Debug Command Listing =======
ATHE
ATGO
ATUR
ATUR3
ATBAx
ATTD
ATSE
ATSH
print help
boot system
upload RAS code
upload RAS configuration file
change baud rate. 1:38.4,2:19.2,3:9.6,4:57.6,5:115.2
download configuration to PC
display seed for password generation
dis
p
la
y
Revision and etc
To update software, system needs to be rebooted.
After system is rebooted, 'Enter Debug Mode' will be displayed.
l ' ' ldSdS d