User`s guide

Prestige 128+ ISDN Router
15-2 System Maintenance
15.1 System Status
The first selection, System Status, gives you information on the version of your
system firmware and the status and statistics of the ports, as shown in below.
System Status is a tool that can be used to monitor your Prestige. Specifically, it
gives you information on your system software version, ISDN telephone line
status, number of packets sent and number of packets received.
To get to the System Status, select number 24 to go to Menu 24 - System
Maintenance. From this menu, select number 1, System Status. There are
five commands in Menu 24.1 - System Maintenance - Status. Entering 1
disconnects the current B1 channel call; 2 disconnects the current B2 channel
call, 3 resets the counters, 4 drops both B1 and B2 and ESC takes you back to
the previous screen.
The table below describes the fields present in Menu 24.1 - System
Maintenance - Status. It should be noted that these fields are READ-ONLY and
are meant to be used for diagnostic purposes.
Menu 24.1 -- System Maintenance – Status
Chan
--
--
Link
Down
Down
Type
0Kbps
0Kbps
TXPkts
0
0
RXPkts
0
0
Errors
0
0
CLU
0%
0%
ALU
0%
0%
Up Time
0:00:00
0:00:00
Total Outcall Time: 0:00:00
Ethernet:
Status: Down
TX Pkts: 0
RX Pkts: 0
Collisions: 0
WAN:
Chan 1 IP Addr:
Chan 2 IP Addr:
Port 1 CLID:
Port 2 CLID:
LAN Packet Which Triggered Last Call:
Press Command:
COMMANDS: 1-Drop B1 2-Drop B2 3-Reset Counters 4-Drop All ESC-Exit