User`s guide

Prestige 128+ ISDN Router
Dial-In Server Configuration 8-3
8.2 LAN-to-LAN Server Application
Your Prestige can also be used as a dial-in server for LAN-to-LAN application to
provide access for the workstations on a remote network. For your Prestige to be
set up as a LAN-to-LAN server, you need to configure the Default Dial-In Setup
to set the operational parameters for incoming calls. Additionally, you must
create a remote node for the router on the remote network (see Chapter 5 -
Remote Node Configuration).
An example of your Prestige being used as a LAN-to-LAN server is shown
below.
Figure 8-2 Example of a LAN-to-LAN Server Application
Prestige Prestige
Remote Network Local Network
LAN-to-LAN
Server