User`s guide

Omni.Net Lite User’s Guide
71 Chapter 4 Using Tone Commands
4.4 Setting Ports Priority
To set the same priority for both two ports, use the ***122*0# command.
To set the PHONE 1 port to have the first priority, use the ***122*1# command.
To set the PHONE 2 port to have the first priority, use the ***122*2# command.
4.4.1 Disabling Call Waiting
To disable call waiting on either port, use the ***211*0# command.
4.4.2 Incoming Call Screening
Use this function to set restrictions on incoming calls.
4.4.2.1 Voice Call
Use 32d*<phone number> [*<sub-address>]# to configure a list of incoming call
phone numbers (with sub-addresses), then use 220*n# to reject or accept the calls with the
phone number in the list.
4.4.3 Outgoing Call Screening
Use this function to set restrictions on outgoing calls, such as allowing or prohibiting a long-
distance or international call.
4.4.3.1 Voice Call
Use 35d*<prefix digits># to configure a list of prefix digits for outgoing call, then use
221*n# to prohibit or allow the calls with the prefix digits in the list.
4.4.4 Caller ID
Use 210*n# to select the device type to enable call waiting caller ID when you have a call
(see Section 3.4.10 on page 66 for more information).