User`s guide

Omni.Net Lite User’s Guide
Chapter 3 Using AT Commands 60
%M3=n Set threshold of data loading to add one channel, the unit is
kbps.
n=0-64, the default is 35.
%M4=n Set a threshold of data loading to drop one channel, the unit is
kbps.
n=0-64, the default is 25.
%M5=n Persist time for monitoring threshold to add or drop one channel,
the unit is 5 seconds.
n=1-255, the default is 24.
%Od=<prefix digits> Create a list of the outgoing call prefix digits for the data port.
d=0-2.
%P0=n Set incoming call screen mode for the data port.
n=0: Accept all incoming calls (default).
n=1: Reject all incoming calls.
n=2: Only accept the calls from the phone number in the list (see
%Id=<phone number> [/<sub-address>]).
n=3: Only reject the calls from the phone number in the list (see
%Id=<phone number> [/<sub-address>]).
%P1=n Set outgoing call screen mode for the data port.
n=0: No restriction (default).
n=1: Prohibit all outgoing calls.
n=2: Only accept the calls with the prefix in the pre-defined list
(see %Od=<prefix digits>).
n=3: Only reject the calls with the prefix in the pre-defined list
(see %Od=<prefix digits>).
%P2=n Select CLIP (Calling Line Identification Presentation) or CLIR
(Calling Line Identification Restriction).
n=0 indicates you select CLIR and the ISDN switch will not pass
your phone number to the destination site.
n=1 indicates you select CLIP and the ISDN switch will pass
your phone number to the destination site.
%S0=<phone
number> [/<sub-
address>]
Assign a phone number to the data port.
<phone number>: Enter up to 32 characters, including digits
from 0 to 9, *, #, hyphen ( -), comma (,) and (‘,’). [‘,’] will be
ignored.
<sub-address>: Enter up to 20 ASCII characters ranging from
“0-9”,” a-z” and “A-Z”.
-P0=n Select transmitting frame size for X.75
n=128-2048 bytes, the default is 254.
-Zd=<phone
number> [/<sub-
address>]
Set a pre-stored phone number for the data port.
d: 0-4
<phone number>: Enter up to 32 characters, including digits
from 0 to 9, *, #, hyphen ( -), comma (,) and (‘,’). [‘,’] will be
ignored.
<sub-address>: Enter up to 20 ASCII characters ranging from
“0-9”,” a-z” and “A-Z”.
Table 14 AT Data Command Sets Requiring an "AT" Prefix
COMMAND OPTION DESCRIPTION