User`s guide

Omni.Net Lite User’s Guide
59 Chapter 3 Using AT Commands
&K Set flow control mode.
&K0 Disable flow control.
&K3 Enable CTS/RTS flow control (default).
&K4 Enable XON/XOFF flow control.
&S DSR (Data Set Ready) signal control.
&S0 Follow DTR signal (default).
&S1 Follow DCD signal.
&V Display all data parameters settings.
&W Save current parameters setting, include &-leading and non-
leading parameters, as user defined profile.
%D0=n Select DTE baud rate when system is powered on.
n=8: 9600 bps
n=11: 19200 bps
n=13: 38400 bps
n=16: 57600 bps
n=17: 115200 bps (default)
n=21: 230400 bps
%D1=n Select DTE attribute when system is powered on.
n=0: 8 data bits, non parity (default)
n=1: 7 data bits, even parity
n=2: 7 data bits, odd parity
%D2=n Dial an outgoing data call automatically if there is pre-stored
dialing number after system is powered on.
n=0: do nothing (default)
n=1: auto-dial after power on
%D3=n The number of retrying to re-dial the outgoing data call once TA
failed to establish the data call.
n=0: don't re-dial.
n=1~10: re-dial for n times until the call is established.
%Id=<phone
number> [/<sub-
address>]
Create a list of the incoming call phone number via the data port.
d=0-4.
<phone number>: Enter up to 32 characters, including digits
from 0 to 9, *, #, hyphen ( -), comma (,) and (‘,’). [‘,’] will be
ignored.
<sub-address>: Enter up to 20 ASCII characters ranging from
“0-9”,” a-z” and “A-Z”.
%M1=n Enable/Disable PAP to CHAP conversion.
n=0: Disable CHAP (default).
n=1: Enable CHAP.
%M2=n Enable/Disable "Dynamic Bandwidth Allocation for Voice Call".
n=0: Disable.
n=1: Enable (default).
Table 14 AT Data Command Sets Requiring an "AT" Prefix
COMMAND OPTION DESCRIPTION