User's Manual

Chapter 1Getting Started
NWD2205 User’s Guide
19
The following table describes the operation of the NWD2205’s LEDs.
1.3 Application Overview
This section describes some network applications for the NWD2205. You can either
set the network type to Infrastructure and connect to an AP or use Ad-Hoc
mode and connect to a peer computer (another wireless device in Ad-Hoc mode).
1.3.1 Infrastructure
To connect to a network via an access point (AP), set the NWD2205 network type
to Infrastructure (see Chapter 4 on page 62). Through the AP, you can access
the Internet or the wired network behind the AP.
Figure 2 Application: Infrastructure
Table 2 NWD2205 LEDs
LED COLOR STATUS DESCRIPTION
Amber Slow
Blinking
The NWD2205 is turned on, connected to an AP, and is
not transmitting or receiving data.
Rapid
Blinking
The NWD2205 is turned on, connected to an AP, and is
transmitting or receiving data. It also blinks when the
WPS feature is being used or a WPS connection is being
initiated.
OffThe NWD2205 is turned off.