User`s guide

Chapter 1 Introduction
NBG6716 User’s Guide
19
Figure 4 Front Panel
The following table describes the LEDs and the WPS button.
Table 1 Front panel LEDs and WPS button
LED STATUS DESCRIPTION
WPS Button Press this button for 1 second to set up a wireless connection via WiFi Protected Setup
with another WPS-enabled client. You must press the WPS button on the client side within
120 seconds for a successful connection. See Section 1.6 on page 17 and Chapter 9 on
page 57
for more information on WPS.
Power On The NBG6716 is receiving power and functioning properly.
Off The NBG6716 is not receiving power.
WAN On The NBG6716’s WAN connection is ready.
Blinking The NBG6716 is sending/receiving data through the WAN with a 1000Mbps
transmission rate.
Off The WAN connection is not ready, or has failed.
Internet On The NBG6716 has an IP connection but no traffic.
Your device has a WAN IP address (either static or assigned by a DHCP
server), PPP negotiation was successfully completed (if used) and the
connection is up.
Blinking The NBG6716 is sending or receiving IP traffic.
Off The NBG6716 does not have an IP connection.
WLAN 2.4/5G On The NBG6716 is ready, but is not sending/receiving data through the 5G
wireless LAN.
Blinking The NBG6716 is sending/receiving data through the 5G wireless LAN.
The NBG6716 is negotiating a WPS connection with a wireless client.
Off The wireless LAN is not ready or has failed.
LAN 1-4 On The NBG6716’s LAN connection is ready.
Blinking The NBG6716 is sending/receiving data through the LAN with a 1000Mbps
transmission rate.
Off The LAN connection is not ready, or has failed.
USB 1-2 On The NBG6716 has a USB device installed.
Blinking The NBG6716 is transmitting and/or receiving data from routers through an
installed USB device.
Off There is no USB device connected to the NBG6716.
Power
LAN 1-4
WAN
WPS
USB 1-2
WPS
Button
Internet
WLAN 5G
WLAN 2.4G