User`s guide

Chapter 1 Introduction

NBG6616 User’s Guide

1 Make sure the power LED is on (not blinking).

2 Press the WPS button for more than three seconds and release it. Press the WPS button on another

WPS-enabled device within range of the NBG6616.

Note: You must activate WPS in the NBG6616 and in another wireless device within two

minutes of each other.

For more information on using WPS, see Section 8.2 on page 56.

1.7 LEDs

Figure 1 Front Panel

The following table describes the LEDs.

Table 1 Front panel LEDs

LED COLOR STATUS DESCRIPTION

Power Green On The NBG6616 is receiving power and functioning properly.

Blinking The NBG6616 is in the process of starting up or default

restoring.

Off The NBG6616 is not receiving power.

Power

LAN 1-4

WAN

2.4G WLAN

USB 1/2

WPS

5G WLAN

WPS Button