User`s guide

Chapter 11 Wireless LAN
NBG5715 User’s Guide
92
The following table describes the labels in this screen.
11.8 The WPS Station Screen
Use this screen when you want to add a wireless station using WPS. To open this screen, click
Network > Wireless LAN 2.4G/5G > WPS Station tab.
Note: After you click Push Button on this screen, you have to press a similar button in
the wireless station utility within 2 minutes. To add the second wireless station, you
have to press these buttons on both device and the wireless station again after the
first 2 minutes.
Figure 51 Network > Wireless LAN 2.4G/5G > WPS Station
Table 35 Network > Wireless LAN 2.4G/5G > WPS
LABEL DESCRIPTION
WPS Setup
WPS Select Enable to activate the WPS feature. Select Disable to turn it off.
PIN Number This displays a PIN number last time system generated. Click Generate to
generate a new PIN number.
WPS Status
Status This displays Configured when the NBG5715 has connected to a wireless
network using WPS or when Enable WPS is selected and wireless or wireless
security settings have been changed. The current wireless and wireless security
settings also appear in the screen.
This displays Unconfigured if WPS is disabled and there are no wireless or
wireless security changes on the NBG5715 or you click Release_Configuration
to remove the configured wireless and wireless security settings.
Release
Configuration
This button is only available when the WPS status displays Configured.
Click this button to remove all configured wireless and wireless security settings
for WPS connections on the NBG5715.
802.11 Mode This is the 802.11 mode used. Only compliant WLAN devices can associate with
the NBG5715.
SSID This is the name of the wireless network (the NBG5715’s first SSID).
Security This is the type of wireless security employed by the network.
Apply Click Apply to save your changes back to the NBG5715.
Cancel Click Cancel to reload the previous configuration for this screen.