User`s guide

Chapter 11 Wireless LAN
NBG5715 User’s Guide
87
The following table describes the labels in this screen.
11.3.4 WPA/WPA2
Select WPA or WPA2 from the Security Mode list.
Figure 46 Network > Wireless LAN 2.4G/5G > General: WPA/WPA2
The following table describes the labels in this screen.
Table 30 Network > Wireless LAN > Security: WPA-PSK/WPA2-PSK
LABEL DESCRIPTION
Security Mode Select WPA-PSK or WPA2-PSK to enable data encryption.
WPA Compatible This field appears when you choose WPA2-PSK as the Security Mode.
Check this field to allow wireless devices using WPA-PSK security mode to
connect to your NBG5715.
Pre-Shared Key WPA-PSK/WPA2-PSK uses a simple common password for authentication.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
Group Key
Update Timer
The Group Key Update Timer is the rate at which the AP sends a new group
key out to all clients.
The default is 3600 seconds (60 minutes).
Apply Click Apply to save your changes back to the NBG5715.
Cancel Click Cancel to reload the previous configuration for this screen.
Table 31 Network > Wireless LAN > General: WPA/WPA2
LABEL DESCRIPTION
Security Mode Select WPA or WPA2 to enable data encryption.
WPA Compatible This check box is available only when you select WPA2-PSK or WPA2 in the
Security Mode field.
Select the check box to have both WPA2 and WPA wireless clients be able to
communicate with the NBG5715 even when the NBG5715 is using WPA2-PSK
or WPA2.