User`s guide

Chapter 3 Tutorial
ZyXEL NWA-3160 Series User’s Guide
68
3.4.3 Setup
In this example, you have already set up the ZyXEL Device in MBSSID mode (see Chapter 10
on page 139). It uses two SSID profiles simultaneously. You have configured each SSID
profile as shown in the following table.
Each SSID profile already uses a different pre-shared key.
In this example, you will configure access limitations for each SSID profile. To do this, you
will take the following steps.
1 Configure the SERVER_1 network’s SSID profile to use specific MAC filter and layer-
2 isolation profiles.
2 Configure the SERVER_1 network’s MAC filter profile.
3 Configure the SERVER_1 network’s layer-2 isolation profile.
4 Repeat steps 1 ~ 3 for the SERVER_2 network.
5 Check your settings and test the configuration.
To configure layer-2 isolation, you need to know the MAC addresses of the devices on your
network, which are as follows.
To configure MAC filtering, you need to know the MAC addresses of the devices Alice and
Bob use to connect to the network, which are as follows.
3.4.4 Configure the SERVER_1 Network
First, you will set up the SERVER_1 network which allows Alice to access secure server 1 via
the network switch.
Table 6 Tutorial: SSID Profile Security Settings
SSID Profile Name
SERVER_1 SERVER_2
SSID
SSID_S1 SSID_S2
Security
Security Profile security03:
WPA2-PSK
Hide SSID
Security Profile security04:
WPA2-PSK
Hide SSID
Intra-BSS traffic
blocking
Enabled Enabled
Table 7 Tutorial: Example Network MAC Addresses
DEVICE LABEL MAC ADDRESS
ZyXEL Device Z BB:AA:99:88:77:66
Secure Server 1 1 AA:99:88:77:66:55
Secure Server 2 2 99:88:77:66:55:44
Workstation C 88:77:66:55:44:33
Switch D 77:66:55:44:33:22
Security gateway E 66:55:44:33:22:11
Table 8 Tutorial: Example User MAC Addresses
USER MAC ADDRESS
Alice 11:22:33:44:55:66
Bob 22:33:44:55:66:77