User`s guide

Chapter 8 Wireless Configuration
ZyXEL NWA-3160 Series User’s Guide
120
See Table 35 on page 113 for information on the other labels in this screen.
8.7.4 AP+Bridge Mode (NWA-3160 and NWA-3163 Only)
Select AP+Bridge as the Operating Mode in the WIRELESS > Wireless screen to have the
ZyXEL Device function as a bridge and access point simultaneously. See the section on
applications for more information.
TKIP (ZyAIR Series
Compatible)
Select this to enable Temporal Key Integrity Protocol (TKIP) security on your
WDS. This option is compatible with other ZyXEL access points including that
support WDS security. Use this if the other access points on your network
support WDS security but do not have an AES option.
Note: Check your other AP’s documentation to make sure it
supports WDS security.
Note: At the time of writing, this option is compatible with
other ZyXEL NWA Series and G-3000/G-3000H access
points only.
AES Select this to enable Advanced Encryption System (AES) security on your
WDS. AES provides superior security to TKIP. Use AES if the other access
points on your network support it for the WDS.
Note: At the time of writing, this option is compatible with
other ZyXEL NWA-3160 access points only.
# This is the index number of the bridge connection.
Active Select the check box to enable the bridge connection. Otherwise, clear the
check box to disable it.
Remote Bridge MAC
Address
Type the MAC address of the peer device in a valid MAC address format, that
is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
PSK Type a pre-shared key (PSK) from 8 to 63 case-sensitive ASCII characters
(including spaces and symbols). You must also set the peer device to use the
same pre-shared key. Each peer device can use a different pre-shared key.
Table 37 Wireless: Bridge/Repeater (NWA-3160 and NWA-3163 Only)
LABEL DESCRIPTIONS