User`s guide

Chapter 8 MBSSID and SSID
NWA3550 User’s Guide
117
8.2 SSID
When the ZyXEL Device is set to Access Point, AP+Bridge or MBSSID mode, you need to
choose the SSID profile(s) you want to use in your wireless network (see Section 6.6 on page
92 for more information on operating modes).
Use the WIRELESS > SSID screen to see information about the SSID profiles on the ZyXEL
Device, and use the WIRELESS > SSID > Edit screen to configure the SSID profiles.
8.2.1 The SSID Screen
Click WIRELESS > SSID to display the screen as shown.
Figure 63 SSID
Enable Roaming Roaming allows wireless stations to switch from one access point to another
as they move from one coverage area to another. Select this checkbox to
enable roaming on the ZyXEL Device if you have two or more ZyXEL Devices
on the same subnet.
Note: All APs on the same subnet and the wireless stations
must have the same SSID to allow roaming.
Apply Click Apply to save your changes.
Reset Click Reset to begin configuring this screen afresh.
Table 33 Wireless: Multiple BSS
LABEL DESCRIPTION