User`s guide

Chapter 11 System
NWA5120 Series User’s Guide
136
The following table describes the labels in this screen.
Table 61 Configuration > System > SNMP
LABEL DESCRIPTION
Enable Select the check box to allow or disallow users to access the NWA using SNMP.
Server Port You may change the server port number for a service if needed, however you must use
the same port number in order to use that service for remote management.
Trap
Community Type the trap community, which is the password sent with each trap to the SNMP
manager. The default is public and allows all requests.
Destination Type the IP address of the station to send your SNMP traps to.
SNMPv2c Select this to allow SNMP managers using SNMPv2c to access the NWA.
Get Community Enter the Get Community, which is the password for the incoming Get and GetNext
requests from the management station. The default is public and allows all requests.
Set Community Enter the Set community, which is the password for incoming Set requests from the
management station. The default is private and allows all requests.
SNMPv3 Select this to allow SNMP managers using SNMPv3 to access the NWA.
Add Click this to create a new entry. Select an entry and click Add to create a new entry after
the selected entry.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The NWA confirms you want to remove it
before doing so. Note that subsequent entries move up by one when you take this action.
# This the index number of an SNMPv3 user profile.
User Name This is the name of the user for which this SNMPv3 user profile is configured.
Authentication This field displays the type of authentication the SNMPv3 user must use to connect to the
NWA using this SNMPv3 user profile.
Privacy This field displays the type of encryption the SNMPv3 user must use to connect to the
NWA using this SNMPv3 user profile.
Privilege This field displays whether the SNMPv3 user can have read-only or read and write access
to the NWA using this SNMPv3 user profile.
Apply Click Apply to save your changes back to the NWA.
Reset Click Reset to return the screen to its last-saved settings.