User`s guide

ENGLISH
10
The device is now ready to connect to your wired network. You can do this now, or once
you have installed the hardware.
V If the wireless clients cannot access the wired network, verify that the IP
address and the subnet mask of the NWA-3100 and the computers on the
network are in the same range. If the ETHN LED is off, check the cables
between the NWA-3100 and your computer or hub.
4 Install the Hardware
4.1 Attaching Antennas
" When facing the front of the NWA-3100, the right antenna (main antenna)
transmits and receives; the left antenna only receives.
10 Change the wireless settings in the wireless stations to match those of the NWA-
3100. Refer to your wireless adapter’s documentation.
" If you change the NWA-3100’s IP address, you must use the new IP
address when you next access the web configurator.
1 Screw the antennas clockwise onto the
antenna connectors on the sides of your
NWA-3100. The antennas should be
perpendicular to the ground and parallel
to each other.
Make sure the antennas are securely
screwed onto the antenna connectors.