User`s guide

NetAtlas Enterprise Ethernet Switch Manager User’s Guide
Chapter 16 Ethernet Port Configuration 138
16.4 Port Link Aggregation
Use the Port Link Aggregation screen to configure a port trunk group and set LACP timeout.
1 In the Device Panel list, select a device and then right-click.
2 Click Configuration, Ethernet Port Configuration and then the Port Link
Aggregation tab.
3 Select the ports from the Port List Panel that you want to apply this configuration.
Figure 99 Ethernet Port Configuration: Port Link Aggregation
The following table describes the fields in this screen.
16.5 Port STP
Use the Port STP screen to configure STP for the selected ports.
VLAN
Trunking
Enable VLAN trunking on ports connected to other switches or routers (but not ports
directly connected to end users) to allow frames belonging to unknown VLAN groups to
pass through the switch.
Apply Click Apply to save the changes.
Table 65 Ethernet Port Configuration: Port VLAN (continued)
LABEL DESCRIPTION
Table 66 Ethernet Port Configuring: Port Link Aggregation
LABEL DESCRIPTION
Group Select the trunk group to which a port belongs.
LACP Timeout Timeout is the time interval between the individual port exchanges of LACP packets in
order to check that the peer port in the trunk group is still up. If a port does not respond
after three tries, then it is deemed to be “down” and is removed from the trunk. Set a
short timeout (one second) for busy trunked links to ensure that disabled ports are
removed from the trunk group as soon as possible. Select from 1 second to 30
seconds.
Apply Click Apply to save the changes.