User`s guide

MWR211 User’s Guide
158
Enable Firewall Rule
Enable Firewall
Rule
Select this check box to activate the firewall rules that you define (see
Add Firewall Rule below)
Apply Click Apply to save the settings.
Add Firewall Rule
Service Name Enter a name that identifies or describes the firewall rule.
MAC Address
Enter the MAC address of the computer for which the firewall rule
applies.
Dest IP Address
Enter the IP address of the computer to which traffic for the application
or service is entering.
The MWR222 applies the firewall rule to traffic initiating from this
computer.
Source IP
Address
Enter the IP address of the computer that initializes traffic for the
application or service.
The MWR222 applies the firewall rule to traffic initiating from this
computer.
Protocol
Select the protocol (TCP, UDP, ICMP or None) used to transport the
packets for which you want to apply the firewall rule.
Dest Port
Range
Enter the port number/range of the destination that define the traffic
type, for example TCP port 80 defines web traffic.
Source Port
Range
Enter the port number/range of the source that define the traffic type,
for example TCP port 80 defines web traffic.
Add Rule Click Add to save the firewall rule.
Firewall Rule
# This is your firewall rule number. The ordering of your rules is
important as rules are applied in turn.
Service Name This is a name that identifies or describes the firewall rule.