User`s guide

Chapter 9 The NAT Configuration Screens
User’s Guide
96
9.3.2 Port Forwarding Rule Setup
Click a port forwarding rule’s Edit icon in the ADVANCED > NAT Configuration > Port
Forwarding screen to activate, deactivate, or edit it.
Figure 53 ADVANCED > NAT Configuration > Port Forwarding > Rule Setup
The following table describes the labels in this screen.
Port Forwarding
#
The number of the item in this list.
Active
Select this to enable this rule. Clear this to disable this rule.
Name
This field displays the name of the rule. It does not have to be unique.
Start Port
This field displays the beginning of the range of port numbers forwarded by this
rule.
End Port
This field displays the end of the range of port numbers forwarded by this rule. If it
is the same as the Start Port, only one port number is forwarded.
Server IP Address
This field displays the IP address of the server to which packet for the selected
port(s) are forwarded.
Action Click the Edit icon to set up a port forwarding rule or alter the configuration of an
existing port forwarding rule.
Click the Delete icon to remove an existing port forwarding rule.
Apply
Click to save your changes.
Reset
Click to restore your previously saved settings.
Table 35 ADVANCED > NAT Configuration > Port Forwarding (continued)
LABEL DESCRIPTION
Table 36 ADVANCED > NAT Configuration > Port Forwarding > Rule Setup
LABEL DESCRIPTION
Active
Select this to enable this rule. Clear this to disable this rule.
Service Name
Enter a name to identify this rule. You can use 1 - 31 printable ASCII characters, or
you can leave this field blank. It does not have to be a unique name.