User`s guide

Chapter 17 The Remote Management Screens
User’s Guide
177
The following table describes the labels in this screen.
17.6 DNS
Click TOOLS > Remote Management > DNS to control DNS access to your WiMAX
Modem.
Figure 98 TOOLS > Remote Management > DNS
Table 76 TOOLS > Remote Management > SNMP
LABEL DESCRIPTION
SNMP Configuration
Get Community Enter the Get Community, which is the password for the incoming Get and
GetNext requests from the management station. The default is public and
allows all requests.
Set Community Enter the Set community, which is the password for incoming Set requests
from the management station. The default is public and allows all requests.
Trap Community Enter the trap community, which is the password sent with each trap to the
SNMP manager. The default is public and allows all requests.
Trap Destination Enter the IP address of the station to send your SNMP traps to.
SNMP
Port You may change the server port number for a service if needed, however you
must use the same port number in order to use that service for remote
management.
Access Status Select the interface(s) through which a computer may access the WiMAX
Modem using this service.
Secured Client IP A secured client is a “trusted” computer that is allowed to communicate with the
WiMAX Modem using this service.
Select All to allow any computer to access the WiMAX Modem using this
service.
Choose Selected to just allow the computer with the IP address that you specify
to access the WiMAX Modem using this service.
Apply
Click to save your changes.
Reset
Click to restore your previously saved settings.