User`s guide

Chapter 17 The Remote Management Screens
User’s Guide
176
17.5.1 SNMP Traps
The WiMAX Modem sends traps to the SNMP manager when any of the following events
occurs:
17.5.2 SNMP Options
Click TOOLS > Remote Management > SNMP to control SNMP access to your WiMAX
Modem.
Figure 97 TOOLS > Remote Management > SNMP
Table 75 SNMP Traps
TRAP #
TRAP NAME DESCRIPTION
0 coldStart (defined in RFC-1215) A trap is sent after booting (power on).
1 warmStart (defined in RFC-1215) A trap is sent after booting (software reboot).
4 authenticationFailure (defined in
RFC-1215)
A trap is sent to the manager when receiving any
SNMP get or set requirements with the wrong
community (password).
6 whyReboot (defined in ZYXEL-
MIB)
A trap is sent with the reason of restart before
rebooting when the system is going to restart (warm
start).
6a For intentional reboot: A trap is sent with the message "System reboot by
user!" if reboot is done intentionally, (for example,
download new files, CI command "sys reboot", etc.).
6b For fatal error: A trap is sent with the message of the fatal code if the
system reboots because of fatal errors.