User`s guide

Chapter 12 The Phone Screens
User’s Guide
129
12.4 Region
Click VOICE > Phone > Region to maintain settings that often depend on the region of the
world in which the WiMAX Modem is located.
Figure 73 VOICE > Phone > Region
The following table describes the labels in this screen.
12.5 Technical Reference
The following section contains additional technical information about the WiMAX Modem
features described in this chapter.
12.5.1 The Flash Key
Flashing means to press the hook for a short period of time (a few hundred milliseconds)
before releasing it. On newer telephones, there should be a "flash" key (button) that generates
the signal electronically. If the flash key is not available, you can tap (press and immediately
release) the hook by hand to achieve the same effect. However, using the flash key is preferred
since the timing is much more precise. The WiMAX Modem may interpret manual tapping as
hanging up if the duration is too long
You can invoke all the supplementary services by using the flash key.
Table 52 VOICE > Phone > Region
LABEL DESCRIPTION
Region Settings
Select the place in which the WiMAX Modem is located. Do not select Default.
Call Service Mode
Select the mode for supplementary phone services (call hold, call waiting, call
transfer and three-way conference calls) that your VoIP service provider supports.
• Europe Type - use supplementary phone services in European mode
• USA Type - use supplementary phone services American mode
You might have to subscribe to these services to use them. Contact your VoIP
service provider.
Apply
Click to save your changes.
Reset
Click to restore your previously saved settings.