User`s guide

Chapter 10 The System Configuration Screens
User’s Guide
106
10.4.1 The Firmware Upload Process
When the WiMAX Modem uploads new firmware, the process usually takes about two
minutes. The device also automatically restarts in this time. This causes a temporary network
disconnect.
A Do not turn off the device while firmware upload is in progress!
After two minutes, log in again, and check your new firmware version in the Status screen.
You might have to open a new browser window to log in.
If the upload is not successful, you will be notified by error message.
Click Return to go back to the Firmware screen.
10.5 Configuration
Click ADVANCED > System Configuration > Configuration to back up or restore the
configuration of the WiMAX Modem. You can also use this screen to reset the WiMAX
Modem to the factory default settings.
Figure 60 ADVANCED > System Configuration > Configuration