User`s guide

Chapter 10 The System Configuration Screens
User’s Guide
105
10.4 Firmware
Click ADVANCED > System Configuration > Firmware to upload new firmware to the
WiMAX Modem. Firmware files usually use the system model name with a "*.bin" extension,
such as "WiMAX Modem.bin". The upload process uses HTTP (Hypertext Transfer Protocol)
and may take up to two minutes. After a successful upload, the system will reboot.
Contact your service provider for information on available firmware upgrades.
A Only use firmware for your WiMAX Modem’s specific model.
Figure 59 ADVANCED > System Configuration > Firmware
The following table describes the labels in this screen.
Dynamic DNS
server auto detect
IP address
Select this if you want the DDNS server to update the IP address of the host
name(s) automatically. Select this option when there are one or more NAT routers
between the WiMAX Modem and the DDNS server.
Note: The DDNS server may not be able to detect the proper IP
address if there is an HTTP proxy server between the
WiMAX Modem and the DDNS server.
Use specified IP
address
Select this if you want to use the specified IP address with the host name(s). Then,
specify the IP address. Use this option if you have a static IP address.
Apply Click to save your changes.
Reset Click to restore your previously saved settings.
Table 40 ADVANCED > System Configuration > Dynamic DNS (continued)
LABEL DESCRIPTION
Table 41 ADVANCED > System Configuration > Firmware
LABEL DESCRIPTION
File Path Enter the location of the *.bin file you want to upload, or click Browse... to find it.
You must decompress compressed (.zip) files before you can upload them.
Browse... Click this to find the *.bin file you want to upload.
Upload Click this to begin uploading the selected file. This may take up to two minutes.
Note: Do not turn off the device while firmware upload is in
progress!