User`s guide

ZyXEL MAX-200M1 Series User’s Guide
90 Chapter 8 LAN
Use this screen to make the ZyXEL Device assign a specific IP address to a specific computer
on the LAN. To access this screen, click Network > LAN > Static DHCP.
Figure 49 Network > LAN > Static DHCP
Each field is described in the following table.
8.2.4 LAN Client List Screen
Note: This screen is empty if the DHCP server is not enabled. You can enable it in
Network > LAN > DHCP Setup.
Use this screen to look at the IP addresses the ZyXEL Device has assigned to DHCP clients on
the LAN. To access this screen, click Network > LAN > Client List.
Table 22 Network > LAN > Static DHCP
LABEL DESCRIPTION
# This field is a sequential value. It is not associated with a specific entry.
MAC Address Enter the MAC address of the computer to which you want the ZyXEL Device to
assign the same IP address.
IP Address
Enter the IP address you want the ZyXEL Device to assign to the computer.
Apply Click this to save your changes.
Reset Click this to set every field in this screen to its default value.