User`s guide

ZyXEL MAX-200M1 Series User’s Guide
88 Chapter 8 LAN
8.2 LAN Screens
8.2.1 LAN IP Screen
Use this screen to set up the ZyXEL Device’s IP address and subnet mask. To access this
screen, click Network > LAN > IP.
Figure 47 Network > LAN > IP
Each field is described in the following table.
8.2.2 LAN DHCP Setup Screen
Use this screen to enable, disable, and configure the DHCP server in the ZyXEL Device. To
access this screen, click Network > LAN > DHCP Setup.
Table 20 Network > LAN > IP
LABEL DESCRIPTION
IP Address Enter the IP address of the ZyXEL Device on the LAN.
Note: This field is the IP address you use to access the ZyXEL
Device on the LAN. If the web configurator is running on a
computer on the LAN, you lose access to the web
configurator as soon as you change this field and click Apply.
You can access the web configurator again by typing the new
IP address in the browser.
IP Subnet Mask Enter the subnet mask of the LAN.
Apply
Click this to save your changes.
Reset
Click this to set every field in this screen to its default value.