User`s guide

ZyXEL MAX-200M1 Series User’s Guide
Chapter 2 Introducing the Web Configurator 35
7 A screen displays to let you choose whether to go to the wizard or the advanced screens.
• Click Go to Wizard setup if you are logging in for the first time or if you want to make
basic changes. The wizard selection screen appears after you click Apply. See Chapter 4
on page 49 for more information.
• Click Go to Advanced setup if you want to configure features that are not available in
the wizards. The main screen appears after you click Apply. See Section 2.2 on page 36
for more information.
• Click Exit if you want to log out.
Note: For security reasons, by default the ZyXEL Device automatically logs you out if
you do not use the web configurator for five minutes. If this happens, log in
again.
Figure 7 Wizard or Advanced Screen
2.1.2 The RESET Button
If you forget your password or cannot access the web configurator, you will need to use the
RESET button to reload the factory-default configuration file. This means that you will lose
all configurations that you had previously and the password will be reset to “1234”.
2.1.2.1 Using The Reset Button
1 Make sure the POWER light is on (not blinking).
2 To set the device back to the factory default settings, press the RESET button for ten
seconds or until the POWER light begins to blink and then release it. When the POWER
light begins to blink, the defaults have been restored and the device restarts.