User`s guide

Chapter 5 Wireless LAN
ericom D1000 modem User’s Guide
57
5.5 The WPS Screen
Use this screen to configure WiFi Protected Setup (WPS) on your Device.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS. See Section 5.10.8.3 on page 71 for more information about WPS.
Note: The Device applies the security settings configured in the General screen (see
Section 5.2 on page 48). If you want to use the WPS feature, make sure you have
set the security mode to WPA-PSK, WPA2-PSK or No Security.
Click Network Setting > Wireless > WPS. The following screen displays. Select Enable and click
Apply to activate the WPS function. Then you can configure the WPS settings in this screen.
Figure 27 Network Setting > Wireless > WPS
Modify Click the Delete icon to delete the entry.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 13 Network Setting > Wireless > MAC Authentication (continued)
LABEL DESCRIPTION