User`s guide

Chapter 4 Broadband
ericom D1000 modem User’s Guide
33
Figure 14 Network Setting > Broadband > Internet Connection
The following table describes the labels in this screen.
Table 3 Network Setting > Broadband > Internet Connection
LABEL DESCRIPTION
Line
Type Select the mode supported by your ISP.
Use Auto Sync-Up if you are not sure which mode to choose from. The Device
dynamically diagnoses the mode supported by the ISP and selects the best
compatible one for your connection.
Other options are Ethernet(ETH1), ADSL2+, ADSL2, G.DMT, T1.413 and G.lite.
General
Mode Select Router (default) from the drop-down list box if your ISP gives you one IP
address only and you want multiple computers to share an Internet account. Select
Bridge when your ISP provides you more than one IP address and you want the
connected computers to get individual IP address from ISP’s DHCP server directly. If
you select Bridge, you cannot use Firewall, DHCP server and NAT on the Device.
Encapsulation Select the method of encapsulation used by your ISP from the drop-down list box.
Choices vary depending on the mode you select in the Mode field.
If you select Router in the Mode field, select IPoE, RFC 1483, PPPoE, or PPPoA.
If you select Bridge in the Mode field, method of encapsulation is not available.
User Name (PPPoA and PPPoE encapsulation only) Enter the user name exactly as your ISP
assigned. If assigned a name in the form user@domain where domain identifies a
service name, then enter both components exactly as given.
Password (PPPoA and PPPoE encapsulation only) Enter the password associated with the user
name above.
Service Name (PPPoE only) Type the name of your PPPoE service here.