User`s guide

Chapter 2 Introducing the Web Configurator
ericom D1000 modem User’s Guide
22
Wireless General Use this screen to turn the wireless connection on or off, specify
the SSID(s) and configure the wireless LAN settings and WLAN
authentication/security settings.
More AP Use this screen to configure multiple BSSs on the Device.
MAC
Authentication
Use this screen to block or allow wireless traffic from wireless
devices of certain SSIDs and MAC addresses to the Device.
WPS Use this screen to use WPS (Wi-Fi Protected Setup) to establish a
wireless connection.
WDS Use this screen to set up Wireless Distribution System (WDS) links
to other access points.
WMM Use this screen to enable or disable Wi-Fi MultiMedia (WMM).
Scheduling Use this screen to configure when the Device enables or disables
the wireless LAN.
Advanced Use this screen to configure advanced wireless settings such as
output power.
Home
Networking
LAN Setup Use this screen to configure LAN TCP/IP settings, and other
advanced properties.
Static DHCP Use this screen to assign specific IP addresses to individual MAC
addresses.
IP Alias Use this screen to partition your LAN interface into dfferent logical
networks.
UPnP Use this screen to enable the UPnP function.
IPv6 LAN Setup Use this screen to configure the IPv6 settings on the Device’s LAN
interface.
File Sharing Use this screen to set up file sharing.
Print Server The print server screen is used to enable the print server function.
Static Route Static Route Use this screen to view and set up static routes on the Device.
IPv6 Static Route Use this screen to configure IPv6 static routes.
QoS General Use this screen to enable QoS and decide allowable bandwidth
using QoS.
Queue Use this screen to configure QoS queue assignment.
Class Setup Use this screen to set up classifiers to sort traffic into different
flows and assign priority and define actions to be performed for a
classified traffic flow.
Game List Use this screen to give priority to traffic for specific games.
NAT General Use this screen to activate/deactivate NAT.
Port Forwarding Use this screen to make your local servers visible to the outside
world.
DMZ Use this screen to configure a default server which receives
packets from ports that are not specified in the Port Forwarding
screen.
ALG Use this screen to activate/deactivate the SIP ALG feature.
Port Isolation General Use this screen to activate/deactivate port isolation.
Port Isolation Use this screen to configure and view port binding groups.
Dynamic DNS Dynamic DNS Use this screen to allow a static hostname alias for a dynamic IP
address.
Security
Table 1 Navigation Panel Summary (continued)
LINK TAB FUNCTION