User`s guide

Chapter 24 Remote Management
ericom D1000 modem User’s Guide
197
Figure 134 Maintenance > RemoteMGMT > WWW
The following table describes the labels in this screen.
Table 80 Maintenance > RemoteMGMT > WWW
LABEL DESCRIPTION
Server Port This displays the service port number for accessing the Device using HTTP or HTTPS. If
the number is grayed out, it is not editable.
Server Access Select the interface(s) through which a computer may access the Device using this
service.
Note: It is recommended if you are allowing WAN access even temporarily to change the
default password (in Maintenance > User Account). To allow access from the
WAN, you will need to configure a WAN to Router firewall rule. See Section 3.7 on
page 34 for information on configuring firewall rules.
Secured Client IP
Address
A secured client is a “trusted” computer that is allowed to communicate with the Device
using this service.
Select All to allow any computer to access the Device using this service.
Choose Range to just allow the computer(s) with an IP address in the range that you
specify to access the Device using this service.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.